Search results for " Batch"
showing 10 items of 36 documents
Achievement of partial nitrification under different carbon-to-nitrogen ratio and ammonia loading rate for the co-treatment of landfill leachate with…
2019
Abstract Partial nitrification (PN) is a technically and economically effective solution for the treatment of wastewater featuring low C/N ratio, allowing to achieve approximately 25% energy saving and 40% carbon source for denitrification. This study investigated the effect of different carbon to nitrogen ratio (C/N) and ammonia loading rate (ALR) on PN performances in a sequencing batch reactor (SBR) treating landfill leachate with municipal wastewater. The aim was to find an optimum range for C/N and ALR to maximize PN performances. Results demonstrated that a proper balancing between ALR and C/N is crucial to achieve high PN efficiency. The results highlighted the existence of an optimu…
Bioplastic recovery from wastewater: A new protocol for polyhydroxyalkanoates (PHA) extraction from mixed microbial cultures
2019
Abstract A new protocol for polyhydroxyalkanoates (PHA) extraction from mixed microbial cultures (MMCs) is proposed. PHA-accumulating capacity of the MMC was selected in a sequencing batch reactor (SBR) fed with a synthetic effluent emulating a fermented oil mill wastewater (OMW). The highest recovery yield and purity (74 ± 8% and 100 ± 5%, respectively) was obtained when using NH4-Laurate for which operating conditions of the extraction process such as temperature, concentration and contact time were optimized. Best conditions for PHA extraction from MMC turned to be: i) a pre-treatment with NaClO at 85 °C with 1 h of contact time, followed by ii) a treatment with lauric acid in a ratio ac…
The role of extracellular polymeric substances on aerobic granulation with stepwise increase of salinity
2018
Abstract A granular sequencing batch reactor (GSBR) worked for 164 days to study the effect of salinity on aerobic granulation. The feeding had an organic loading rate (OLR) of 1.6 kg COD⋅m −3 ⋅d −1 and a gradual increase of salinity (from 0.30 to 38 g NaCl − ⋅L −1 ) to promote a biological salt-adaptation. First aggregates (average diameter ≈ 0.4 mm) appeared after 14 days. Extracellular polymeric substances (EPSs) analyses revealed that proteins were mainly higher than polysaccharides, and microorganisms metabolized EPSs as additional carbon source, mostly in feast phase, to face the energy demand for salinity adaptation. No significant worsening of organic matter removal was observed. Th…
Kinetics of vinyl acetate biodegradation by Pseudomonas fluorescens PCM 2123
2018
Abstract The microbial degradation of vinyl acetate (VA) by Pseudomonas fluorescens PCM 2123 strain was studied in both batch and continuous modes. The purpose of the experiments was to determine the kinetic model of the cell growth and biodegradation rate of vinyl acetate (VA), which was the sole carbon and energy source for tested microorganisms. The experiments, carried out in a batch reactor for several initial concentrations of growth substrate in the liquid phase ranging from 18.6 to 373 gsubstrate·m−3 (gs·m−3) made it possible to choose the kinetic model and to estimate its constants. The Haldane inhibitory model with the values of constants: μm = 0.1202 h−1, KS = 17.195 gs·m−3, Ki =…
Effect of Temperature on N2O and NO Emission in a Partial Nitrification SBR Treating Reject Wastewater
2017
Temperature is a very important parameter during nitritation, having a direct effect on ammonia oxidation rate (AOR) and enzymatic activities which relate to both N2O and NO emission. This study aims at investigating the effect of temperature on AOR, N2O and NO production in an enriched ammonia oxidizing bacteria (AOB) sequencing batch reactor (SBR) performing partial nitrification (PN) of synthetic reject wastewater. To achieve that, a SBR was subject to several shifts in temperature (in the range of 30 to 15 °C, 5 °C for each decrease). Cycle studies, which contain two aeration phases, were conducted under each temperature. The results showed that AOR specific exponentially correlates wit…
C3N4 for CO2 photoreduction: catalyst performance and stability in batch and continuous reactor
2019
In this study, various C3N4 samples were prepared and characterized. CO2 photoreduction was carried out by using C3N4 as powder and coated on glass support in a batch reactor or embedded in a Nafion membrane in a continuous reactor
Calcium phosphate precipitation in a SBR operated for EBPR: interactions with the biological process.
2008
The aim of this paper is to study the precipitation process in a sequencing batch reactor (SBR) operated for EBPR (enhanced biological phosphorus removal) and the possible effects of this phosphorus precipitation in the biological process. Four experiments were carried out under different influent calcium concentration. The experimental results and the equilibrium study, based on the Saturation Index calculation, confirm that the process controlling the calcium behaviour in a SBR operated for EBPR is the calcium phosphate precipitation. This precipitation takes place at two stages initially precipitation of the ACP and later crystallization of HAP. Also the accumulation of phosphorus precip…
Aerobic granular sludge treating shipboard slop: Analysis of total petroleum hydrocarbons loading rates on performances and stability
2018
Abstract The work focuses on the feasibility of treating slop with aerobic granular sludge. For this purpose, a 3.5 L granular sequencing batch reactor was activated and it was monitored for 156 days. The experimental campaign was divided into two periods, named Period I (100 days) and Period II (56 days). Total Petroleum Hydrocarbon (TPH) concentration in the slop was, on average, equal to 6.8 ± 1.5 mg L−1 and 13 ± 1.5 mg L−1 in Period I and Period II respectively. The obtained results during the first experimental period indicated that about 80 days were required to reach steady state with mature granules, when TPHs removal efficiency was approximately 90%. The results indicated that both…
Shortcut nitrification-denitrification by means of autochthonous halophilic biomass in an SBR treating fish-canning wastewater
2017
Abstract Autochthonous halophilic biomass was cultivated in a sequencing batch reactor (SBR) aimed at analyzing the potential use of autochthonous halophilic activated sludge in treating saline industrial wastewater. Despite the high salt concentration (30 g NaCl L −1 ), biological oxygen demand (BOD) and total suspended solids (TSS), removal efficiencies were higher than 90%. More than 95% of the nitrogen was removed via a shortcut nitrification-denitrification process. Both the autotrophic and heterotrophic biomass samples exhibited high biological activity. The use of autochthonous halophilic biomass led to high-quality effluent and helped to manage the issues related to nitrogen removal…
A methodology for sequencing batch reactor identification with artificial neural networks: A case study
2009
This paper presents a systematic methodology based on the application of artificial neural networks for sequencing batch reactor (SBR) identification. The SBR is a fill-and-draw biological wastewater technology, which is specially suited for nutrient removal. The proposed approach makes optimal use of the available data during the training stage and it is aimed at achieving high generalization ability. For this purpose, a wide range of experimental conditions, including different solids retention times and influent characteristics, has been used. The methodology is successfully applied to develop a soft-sensor for monitoring a laboratory-scale SBR operated for enhanced biological phosphorus…